3 1/8” Pillow Block Bearing UCP216-50 for Crusher

Description-3 1/8”Bore Pillow Block Bearing UCP216-50

GJP Bar Code Number: 6935329802476

GJP 3 1/8″ Pillow Block Bearing UCP216-50 For Crusher, Which has grease fitting and Cap on 45 degree angle, and the insert bearing has a wide inner ring with two set screws for locking on the shaft, bearing insert and housing are normally assemblied with J7 tight fitting, this items are widely used.

Interchange

GJP: UCP216-50

AMI: UCP216-50

IPTCI: UCP216-50

NSK: UCP216-50

Peer: FHSP216-50G

Fafnir: RASC-3 1/8″

Fafnir: YAS-3 1/8″

RHP: NP-3 1/8″

SKF: SY 3 1/8″ TF

Technical Data for GJP UCP216-50

Housing No.: P216

Bearing Insert No.: UC216-50

Material For Bearing Insert: 100% Chrome Steel Gcr15(AISI 52100)

Grade For Steel Ball: G10 Grade Chrome Steel Ball.

Materia of Bearing Cage: #10 Steel

Stopping Pin Material on OD of OR: Chrome Steel Gcr15

Sealing Type: F Seal, L3 Seal And Normal NBR Seal are available for customers’selection.

Set Screw Material: 35CrMo

Grease: 20% to 50% Mobil Grease

Set Screw Surrounding Hardness: HRC49 to HRC 50

Bearing Race and Steel Ball Hardness: HRC59 to HRC62

Bearing Housing Material: HT200 Grey Cast Iron

Housing Color: Green, Blue, Grey, Black Color available.

Whole Unit Assembly Type: J7 Tight Fitting

Housing Weight: 5.8KGS

Quality Control: Under ISO: 9001: 2008 Certificate

Package: 1*1 Single GJP poly bag+1*1 Single GJP color box+1*1 GJP outer carton

FAQ

Hello, we’re from Chicago in USA, In our last consignment, we bought some of HCFS207-20 and SBFTD205-16, but when we receved the cargo, we found that part of quantity has the problem of the paint fall off from the housing, what’s the problem of it?

About the paint problem, please check when you confirm the order to your suppliers, which kind of packing way you use, if we use the bulk packing, then during transportation, the housing might knock each other, and it would cause the falling off the paint, another reason might be caused by the bearing housing suppliers, if the producer paint too thick housing, it would have this problem also, the iron material could not stick to the paint, so it’s important also to control the volumn when the housings are finally electrostatic spraying.